Whether the job is patching a single damaged section, replacing an entire aging supply line, or running new pipe for an addition, our plumbers match the approach to both the home’s age and the homeowner’s budget. Not every older pipe needs full replacement immediately, but understanding which sections are at risk matters.

Homes still running galvanized pipe from Aurora’s original construction boom are the ones we most often recommend a full repipe for, since patching individual leaks in aging galvanized line tends to become a repeating cost. Our leak detection team frequently identifies the first sign of this kind of aging pipe before it becomes a bigger problem.

• Single isolated leak in newer PEX or PVC: Usually a straightforward, affordable repair.
• Repeated leaks in galvanized pipe: A sign the whole line is corroding and a full repipe is the more cost effective long term choice.
• Reduced water pressure throughout an older home: Often caused by internal corrosion narrowing galvanized pipe over years.
• New addition or remodel: Requires new pipe installation matched to the rest of the home’s system.

The right call depends heavily on the age and material of the existing plumbing.

How do I know if I need a repair or a full repipe?

A single leak in an otherwise healthy line, especially modern PEX or PVC, is almost always a straightforward repair. But if an Original Aurora home has had more than one or two pipe leaks in different spots within a couple of years, that pattern usually means the galvanized pipe itself is corroding throughout the system, and a full repipe becomes more economical than repeatedly patching individual failures.

Is my home’s low water pressure a pipe problem?

It can be. Galvanized pipe corrodes from the inside over decades, gradually narrowing the interior diameter and restricting flow. If pressure has dropped gradually across the whole house rather than at just one fixture, and the home still has original galvanized supply lines, that internal corrosion is a common and likely cause.

Can you repair just one section of pipe instead of the whole line?

Yes, when a single section of pipe has failed and the rest of the line is in reasonable condition, a targeted section repair is often the most cost effective solution, and we clearly explain when that approach makes sense versus when a broader replacement is the better long term investment.